You are here: Home » Products » FLOW » Orifice Plates » MRK

EMCO Orifice Plate with Carrier Rings and Corner Pressure Tappings
Series MRK for Insertion Between Flanges

Principle:EMCO orifice plate are used as primary elements in flow measurement of liquid, gas and steam according to the differential pressure principle

Images & drawings

Dimensions for DIN flanges

For dimensions of flanges click the product sheet at the top of the page.

Construction
Design and calculation standards
ISO 5167-2, ASME MFC-3M, DIN 19205, Shell Flow Meter Engineering Handbook, L. K. Spink, AGA no. 3
Sizes
DN 50 - 1200, 2" - 42"
Pressure rating
PN 10 - 400, 150 - 2500 lbs
Plate thickness
3 - 10 mm depending on plate size
Vent or drain hole
On Request
Plate Material
AISI 316, other on request
Carrier ring material
Carbon steel P265GH, AISI 316, other materials on request.
Mounting Style
Between flanges with flat or raised face or groove according to DIN 2526, 2513 or 2512, RF according to B 16.5
Pressure taps
3/8", 1/2" BSP male, Ø 12 mm, 1/2" NPT
Tap Length
150 mm, others on request.
Tap Location
Normally same side of carrier rings, except for vertical mounting where an angle of minimum 90° is required otherwise to be stated with order
Orifice plate shapes
Square edge concentric, square edge eccentric, conical, 1/4 circle, segment. The plate is bevelled on the down stream side except for 1/4 circle orifice plate
Marking
The orifice plate is marked with "+" and"-" and flow direction.
Technical Data
Accuracy
+/- 0,6 % for β < 0,6 and equal to β for β values above 0,6
Pressure loss
Depending on β, for β equal to 0,6 : ca. 60 % of the differential pressure measured
Limits for Reynolds No
Re > 1260 x β2 D according to ISO 5167 2000 < Re < 108 according to ASME MFC-3M
Accessories
Shut-off valves and condensing chambers for steam flow measurement. Flange assembly complete with bolts, nuts and gaskets